Quality workmanship
We take pride in our work. That's why we use the finest materials
Water Resistant Barrier
Two-Ply Super Jumbo Tex 60 Minute is engineered for residential and commercial construction applications that demand the maximum water and moisture protection available. Delivering over fifteen times the minimum water resistance requirement for Grade “D” paper, it is an industrial strength product that stands up in tough jobsite and environmental conditions. Two-Ply Super Jumbo Tex
Control Joints
Control and expansion joints are designed to relieve stresses on stucco walls to prevent extensive cracking from occurring where the material expands and contracts or where the home experiences framing movement. Install control joints at least every 144 square feet. When possible, try to align control joints with window or door openings to provide protection
Window Flashing Tape
DuPontTM Flashing Tape is a self-adhered flashing that is designed to help protect the heads and jambs of windows. These areas can be subjected to wind-driven rain, which can find its way into a window and cause water damage. Flashing is an essential part of construction and protection of your house. Its aggressive adhesive forms
Kick Out Flashing
Kickout flashings are used where a lower roofline terminates against a vertical wall. The kickout is installed above the rain gutter and/or drip edge flashing where the roof meets a vertical wall. It kicks out rain water and diverts it away from the lower wall. Without a kickout flashing, the water misses the gutter and
The Finish Coat
The finish coat is the final coat of stucco applied to the wall coming with two type of properties. Acrylic Finish Coat – A 100 percent acrylic-based textured finish. Made with Dirt Pick-Up Resistance (DPR) meaning the surface of the finish hardens and does not soften again under heat. The non-tacky surface provides high resistance
The Brown Coat
The brown coat is applied over the scratch coat to prepare the plaster base for the finish coat application. The brown coat is the second coat of stucco applied to the wall. The brown coat creates the level surface that’s desirable for the finish coat. Mix the brown coat, following the manufacturer’s instructions. Ensure that
Wood Sheathing Surface
On wooden walls, sheathing should be installed continuously, positioning the wood boards horizontally. The builder should leave a 1/8 space between the edge of the boards to allow moisture expansion. Make sure wood sheathing has the proper moisture content and grade to prevent unnecessary cracks in the wall.
How To Stucco
In order to understand how to stucco, it’s important to gain a good understanding of the stucco structures and the reason why it has been successfully used for so many years in residential and commercial construction. The term ‘Stucco’ is used to describe a type of exterior plaster applied as a two or three part
The Scratch Coat
The scratch coat is the first coat of stucco applied to the wall. Its name comes from the fact that it’s scratched horizontally to promote both a mechanical and chemical bond between it and the brown coat, which is applied next. Prepare the scratch coat according to the manufacturer’s instructions. Ensure that the proper proportions
Cure Times For Stucco
Stucco is a cement-based product and as such requires curing, the same as any Portland cement-based product. There are requirements for cure times and there are recommendations for best results. The main intent of cure times is to allow the cement basecoat to set and shrink before proceeding with final decoration (finish coat). The cure